Whether you need a gift card holder for Father’s Day or a graduation party–this is so cute and easy to make! Simply swap out DSP for a different look!

Cut a 11″ x 4.25 piece of cardstock (I used Basic Black Cardstock for the card above).  Score at 5.5″, turn, score at 2.5″.  Punch the end of the page with 3/4″ punch and fold it over to make the flap for the gift card. You could also use the 3/4″ Layering Circles Dies.

Use Stampin’ Seal adhesive for the sides of the gift card holder. See the image below.

I cut a 5.25″ x 4″ piece of Basic Gray Cardstock for the inside of the gift card holder. Write a note or stamp a greeting inside!

I cut a rectangle for the gift on the top of the card and used the bow from the Gift Wrapped Bundle for the present’s bow. I stamped the bow in Pacific Point ink on Pacific Point Cardstock and cut it out with the punch from the bundle.

I used the Well Suited DSP for the card.

You could also make a birthday gift card holder with some birthday DSP! Check out my Father’s Day Card Supply List and some different color combinations I made!